CleanSpace
CleanSpace Donning Guide
Guide
2 Pages
Preview
Page 1
CLEANSPACE™ DONNING GUIDE 1. BEFORE DONNING
3. DONNING FULL MASK
2. DONNING HALF MASK
Loosen the mask straps and Don the full face and tighten straps to fit.
Check you have all parts - power unit with harness & neck support, mask & filter
Click ONE side of the mask to the power unit. Leave the other side open
Inspect for damage
Turn power unit on. NOTE the motor and air will not flow until the respirator is donned and has detected breathing.
Place unit around the back of the neck with the mask facing forward hanging under the chin. Position the face piece on the face with the chin in the mask and the apex of the mask comfortably on the nose bridge.
Check the power unit is charged (three green lights) and filter is in place.
To Adjust, have the Mask and power unit in place, the adjust buttons on either side can be used to tighten or loosen the system.
Turn power unit on. NOTE the motor and air will not flow until the respirator is donned and has detected breathing. Place the power unit at the back of the neck and clip on to the full face mask on both sides. Start breathing. The motor and air flow should start.
Loosen Remove
IMPORTANT: DON THE RESPIRATOR BEFORE ENTERING THE CONTAMINATED AREA Please read CleanSpace Respirator User Instructions before use FOR MORE INFORMATION ON TRAINING AND CARING FOR YOUR CLEANSPACE RESPIRATOR VISIT OUR WEBSITE OR CONTACT US AT WWW.CLEANSPACETECHNOLOGY.COM
CleanSpace Technology Pty Ltd Ground Floor, 16-18 Carlotta St Artarmon NSW 2064, Australia P +612 8436 4000 E [email protected]
CLEANSPACE™ DOFFING GUIDE 1. DOFFING IMPORTANT: BEFORE DOFFING
LEAVE THE CONTAMINATED AREA
Loosen the adjustment straps of the mask Find the rough button near the air clip and unclip one side of the mask and remove the mask and power unit.
2. CLEAN
3. CHECK
Unclip the mask from the power unit Clean the mask with warm soapy water and wipe down the power unit.
Check the parts for damage.
4. CHARGE Charge the power unit ready for use in the next shift.
Check the filter alarm and replace filter if required
IMPORTANT: DO NOT SUBMERGE OR EXPOSE THE POWER UNIT TO EXCESS WATER
NOTE: the power unit will automatically switch off after 10 secs.
Please read CleanSpace Respirator User Instructions before use FOR MORE INFORMATION ON TRAINING AND CARING FOR YOUR CLEANSPACE RESPIRATOR VISIT OUR WEBSITE OR CONTACT US AT WWW.CLEANSPACETECHNOLOGY.COM
CleanSpace Technology Pty Ltd Ground Floor, 16-18 Carlotta St Artarmon NSW 2064, Australia P +612 8436 4000 E [email protected]