Spare Parts Instruction
Replacing the Loader Board
Smm Hex wrench
The installer is required to use an ESD (electro-static discharge) Grounding Wrist strap during this
procedure to avoid unintentional damage to the electronic devices in the machine.
Do not remove any cards or IC chips from their antistatic containers until you are ready to install them.
When removing cards or chips from a system, immediately place them in an antistatic bag or container.
When handling cards or IC's, hold them by their edges. Avoid touching the components and connector
leads on the card. Avoid touching the leads on the IC .
Do not slide cards or IC's over any surface. Avoid plastic, vinyl, and Styrofoam in your work area
us improving our service.
Check that the machine is switched off.
Open the cabinet using a Smm Hex wrench.
Disconnect all the cables connected to the
Loader board, noting their positions.
Remove the board by unscrewing the four small
nuts holding the board, using a 4mm wrench.
Mount the new board and secure them using the
Re-connect all the cabling.
Close the cabinet.
To continuously improve our customer support,
please send the following information to the
• Running Time:
• Serial number:
Reason for change:
• Changed component:
E-mail - fic.customer
Switch on the machine and enter Service/Diagnose/Internal.
VerifY the function ofthe loader using the Load Unload soft keys.
Press Load and the loader must retract into the machine and the Loader switch must indicate loaded.
Press Unload and the loader must extend away from the machine and the loader switch indicates unloaded .
Working time necessary:
GAMBRO Renal Products
Reference: PO P·2279
Effective date: 2006-09-04