ABBOTT LABORATORIES

i-STAT System

i-STAT User Guide Rev Date 4 Feb 2016

User Guide

8 Pages

Quality Check Messages and Codes  (continued)  Message  Cause  Action  Analyzer Error, Use Electronic Simulator  Handheld detects problem from which it is likely to recover... Insert the Electronic Simulator... f PASS, continue to use handheld... Analyzer Error, See Manual  Handheld detects problem from which it may not recover... Insert Electronic Simulator... f PASS, insert a cartridge with sample or control... f the code does not reappear, continue to use handheld... No display  Disposable batteries dead or rechargeable battery fully discharged... eypad not responding... tart switch broken... Change disposable batteries or recharge battery... f still no display, call Support Services... Cartridge Locked does not disappear after test cycle completed  Dead battery(s)... echanical problem... Wait until handheld turns off... urn handheld on... f resets, remove cartridge... f not, change or recharge battery(s) and turn handheld on... i-STAT  06F16-57  (01)00054749002139 ®  i-STAT 1 User Guide  Abbott Point of Care Inc... 00 and 200 Abbott Park Road Abbott Park, IL 60064 • USA  Emergo Europe Molenstraat 15 2513 BH The Hague The Netherlands  For information related to Article 33 of the EU REACH regulation (EC No... 907/2006), please refer to PMIS... bott... m... f you have issues logging into the website, contact Abbott at: ... abbott... ACH@abbott... m... 2016 Abbott Point of Care Inc... ll rights reserved... rinted in USA... -STAT is a registered trademark of the Abbott Group of Companies in various jurisdictions... Art: 714254-01Q  Rev... ate: 04-Feb-16  ®   System Components  Quality Check Messages and Codes i-STAT Cartridges  i-STAT 1 Analyzer  Electronic Simulator  i-STAT 1 Downloader  i-STAT 1 Downloader/Recharger  i-STAT Printer  Message  Cause  Action  Date Invalid, Check Clock  Date outside six month lifetime of software... Select 5-Clock Set from Administration Menu... Password protected...  Dead Batteries, Replace Batteries  Insufficient power to complete a test cycle... Replace disposable batteries or recharge the rechargeable battery... Temperature Out of Range, Check Status page  Temperature outside operating range of 16 to 30 °C... Check handheld temperature by pressing 1 for Analyzer Status under the Administration Menu... ove handheld to warmer area if below operating range or to cooler area if above the range... Invalid or Expired CLEW  Software expired or corrupt... Verify that the handheld’s date is correct... hange software if expired... pdate again if not expired... Analyzer Interrupted, Use Another Cartridge  Last cartridge run not completed... Check the battery pack inserted properly... heck for Low Battery startup warning... Cartridge Error  Usually problem with sample or cartridge filling... Use another cartridge... f same code repeats more than twice, try another handheld... Cartridge Preburst  Calibrant pack burst before cartridge inserted into handheld... Use another cartridge - do not press on center of cartridge... heck that cartridges have not been frozen... Unable to Position Sample  Cartridge not sealed... lot in sample... berrant cartridge... Use another cartridge... Sample Positioned Short of Fill Mark  Cartridge underfilled... Use another cartridge - fill to Fill Mark... Sample Positioned Beyond Fill Mark  Cartridge overfilled... Use another cartridge - do not fill beyond Fill Mark... Test Cancelled by Operator  User did not respond to mandatory prompt before handheld time out... No action required... Cartridge Type Not Recognized  Software does not recognize cartridge... Update software... heck to see if cartridges are expired... For in vitro diagnostic use... ee System Manual for instructions... artel Printer  Intended Use: The i-STAT 1 Analyzer is intended for use with i-STAT cartridges for the in vitro quantification of various analytes in whole blood...   15
File Type: PDF
File Size: 965 KB
File Name: i-stat_user_guide_rev_date_4_feb_2016.pdf

By clicking Download you are confirming this is the correct document for your purposes
and that you agree to our Terms & Conditions