UV-360 How to Use Guide

UV-360 www.clinell.com

How to use The Clinell UV-360 room sanitiser is faster than any other UV solutions currently available. It is also significantly faster and easier than any ‘non-touch’ room decontamination solutions currently available.

1.

Before using the UV unit you must perform regular cleaning as per local policy. This is to remove any visible soiling which may reduce the efficacy of the machine. First clean the bathroom.

2.

After cleaning, roll the UV unit into the bathroom and apply the appropriate warning signage. Ensure the shower curtain is bunched into the middle and the toilet seat is up. Set the unit to run for 10 minutes. You will have 30 seconds to leave the room, ensure you close the door behind you.

4.

5.

+10 MINS

+10 MINS

When you have finished, roll the UV unit to the left, at the foot of the bed. Ensure all bed rails are up and all the linen is removed. Expose common touch points by opening drawers and cupboards etc. Set the unit to run for 10 minutes. You will have 30 seconds to leave the room, ensure you close the door behind you.

After 10 minutes enter the room, it will smell of ionisation which is normal. Turn items such as remote controls upside down. Re-position the unit to the right hand side, at the foot of the bed. Set the unit to clean for 10 minutes. You will have 30 seconds to leave the room, ensure you close the door behind you.

3.

Whilst the UV unit is disinfecting the bathroom, perform a regular terminal clean in the ward room, ensuring the room is cleaned in a thorough and methodical manner, as per local guidelines and/or hospital policy.

6.

After 10 minutes enter the room, it will smell of ionisation which is normal. Wear fresh PPE and make the bed and tidy the room. Dispose of PPE, remove the UV unit and all the warning signage.

powered by

UltraViolet Devices, Inc.