Brief Operating Instructions
2 Pages
Preview
Page 1
Brief operating instruction ALPHASTAR
1132.01AX/BX 1132.02AX/BX
Control of functions: The electrohydraulically driven functions of the operating table may be controlled by cable-connected hand control or optional infrared hand control optional foot switch emergency control switch (override) LED for connecting to the mains: green blinking signal when the operating table is connected to the mains and the control system is switched on. OFF: the operating table is switched off, all functions are stopped immediately (emergency shutdown).
LOCK: Table locked yellow LED: when the operating table is locked.
LED for battery charge level: blinking red signal when the batteries of the operating table need to be recharged as soon as possible. ON: When the control system is switched on, the yellow LED lights up: the functions can be controlled by pressing the keys. UNLOCK: Table unlocked red LED lights up: the operating table is standing on its castors and can be displaced.
Normal: Patient orientation: normal direction the green LED lights up
REV: Patient orientation: reverse direction the yellow LED lights up
BACKW.: travelling device backward (works only with built-in kit motor-driven castor 1132.60A)
FORW.: travelling device forward (works onlywith built-in kit motor-driven castor 1132.60A)
TREND: table top - Trendelenburg
REV.: table top - reverse Trendelenburg
UP: table top up
DOWN.: table top down
TILT L.: lateral tilt left
TILT R.: lateral tilt right
BACK UP: back plate up
Englisch
LEG UP: leg plate up
FLEX: Flex position (kidney/gall bladder elevation) controls the functions inclination and back alternately until the flex position is achieved.
BACK DN: back plate down LEG DN: leg plate down REFLEX: Reflex position controls the functions back and inclination alternately until a V-position is achieved. LEVEL: for horizontal alignment of the table top
GK113201GB02
The back plate, seat plate and leg plate adjustments are motor-driven. The head rest is adjusted manually. The head rest may be attached at either end of the operating table, thus providing two possible patient orientations on the operating table. NORMAL orientation (Fig. 1) REVERSE orientation (Fig. 2)
Fig. 1: NORMAL orientation with patient up to 500 lbs (225 kg)
Fig 2: REVERSE orientation with patient up to 300 lbs (135 kg)
Safety precautions Do not use this table for patients exceeding the 500-pound limit (225 kg). For patients weighing up 300 lbs (135 kg) all surgical interventions are possible in both patient orientations on the locked table. For patients weighing between 300 lbs up to a maximum of 500 lbs (135 to 225 kg), surgical procedures are only permissible with the normal patient orientation on the locked table. Displacement of the table with patient up to 300 lbs (135 kg) is allowed only with maximum height of the table top of 39 inches (1m) In case of errors the function in question can be stopped immediately by either pressing the key for the opposite movement or switching off the control system (OFF). Particularly accessory units with high weights or long lever arms (such as retractor systems etc.) may cause damage to the side rails.
In case of failure of the hand control or the electronic control for instance, the most important functions can be controlled via the control panel at the upper column casing (override system). For detail information refer to operating instruction GA113201GB04. MAQUET Aktiengesellschaft, Kehler Straße 31 D-76437 Rastatt, Surgical Tables Division Phone: ++ 49 (07222) 9 32-0, Fax: ++ 49 7222 9 32-571 Service-Hotline: ++ 49 7222 932 465, e-mail: [email protected], Internet: http://www.maquet.com